[. . . ] HID Wall Pack - WL Series INSTALLATION INSTRUCTIONS Lamp Types: High Pressure Sodium 35 Watt, & 50 Watt Models: WL035HPS & WL050HPS IMPORTANT: FOR OUTDOOR USE ONLY NOT FOR USE IN HAZARDOUS ATMOSPHERES ELECTRICAL REQUIREMENTS Read instruction sheet carefully before installing fixture. [. . . ] Connect the selected voltage fixture wire to the Black (hot) supply wire. Connect the White fixture wire marked "COM" to the White (neutral) supply wire. Connect the bare copper (fixture ground) wire to the supply grounding wire. Install fixture over mounting plate nipple and tighten locknut to secure fixture body to mounting. Install, close, and secure lens cover with (2) screws making sure that the gasket is properly seated. To weatherproof fixture, seal all holes in housing (mounting conduit, plugs, photocontrols, etc. ) with silicone sealant. To operate, restore power to the circuit and switch light on. Figure 3 COM X2 LAMP REPLACEMENT 1. Remove old lamp and replace with new lamp of correct type and wattage. [. . . ] FOR FURTHER INFORMATION CONTACT YOUR DISTRIBUTOR OR INTERMATIC INCORPORATED - SPRING GROVE, ILLINOIS 60081 (815) 675-7000 www. intermatic. com 158HL12113 [. . . ]